Fully automatic loading machine in the normal operation process suddenly can not manipulate the feeding situation, there may be a variety of reasons for this. The following will provide you with details of some of the possible causes and solutions to help you better understand the troubleshooting process of automatic feeding machine.

　　First, check the power supply and connection of the feeding machine. Make sure the power cord is properly connected and energised, and check whether the signal light on the control panel is normally lit. If there is no power or the signal light does not light up, the power supply may be poorly wired or the circuit board may be faulty. At this point, you can check the power cord and plug connection to ensure that the power cord is working properly, or contact the after-sales service department for further investigation and repair.

　　Second, check the sensors and control components. Automatic loading machines are usually equipped with multiple sensors to detect the entry and position of materials, as well as control elements to manipulate the loading process. Make sure that the sensors are not damaged or loose, and check whether their connection wires are normal. If the sensors are damaged or have loose connections, the loader may not be able to accurately sense the state of the material and therefore not be able to manipulate the loading process. In this case, you can check the working condition of the sensor and reconnect or replace the damaged sensor.

　　Third, check the mechanical parts of the feeding machine. Mechanical parts in the automatic feeding machine, such as conveyor belt, feeder, etc., may be faulty or blocked. Check whether the conveyor belt is functioning properly and whether it is blocked by debris. If the conveyor belt is not functioning properly or is blocked by debris, the material may not be loaded smoothly. In this case, you can check the working condition of the conveyor belt and other mechanical parts, clear the blockage or fix the malfunction.

　　Automatic Feeding Machine.jpg

　　In addition, you need to check the software settings and programmes of the automatic feeding machine. Make sure that the settings and programmes of the loading machine are correct and compatible with the control system used. Sometimes, incorrect settings or programming may cause the loader to not be able to manoeuvre the loader properly. In this case, you can check the correctness of the settings and programmes and adjust or update them as needed.

　　Finally, if the above troubleshooting methods still do not solve the problem, it is recommended to contact professional maintenance personnel or after-sales service department for diagnosis and repair. Automatic loading machine is a complicated equipment, which requires professional technicians for maintenance and debugging. It is not recommended that users disassemble or repair on their own, so as not to further damage the equipment or lead to safety hazards.

　　To sum up, the problem that the automatic loading machine can not control the loading may involve power connection, sensor failure, mechanical component failure, software settings and other aspects. By checking the possible causes one by one and taking appropriate solutions according to the specific situation, it can help restore the normal operation of the feeding machine. If the problem cannot be solved, it is recommended to seek professional technical support and maintenance services.